DAZStudio - Tipps & Tricks
  1. dForce is exploding

    Problem:


    dForce explodes

    Solution:



    • Set the "bend stiffness" to .25 instead of .5

    • Set the "buckling stiffness" to its minimum. Adding in decreases to either stretch stiffness or shear stiffness was enough to make it behave properly.

    • Set the"dynamics strength" to 90 avoids it from exploding, but also limited the amout of draping.

    • Go to zbrush and change the geometry of the model. Retopologizing so that it had only quads instead of a mix of quads and triangles. The draping is more interesting and better.
      "Decimated" versions (triangle-based) of the original model explode in the same way as the original. Decimated versions of the retopologized version seem not to explode.


    Summary:

    Clean topology matters. It's probably necessary to have non-intersecting "watertight" meshes, but it's not sufficient.
    If you have no control over the topology, try simply tweaking the bend stiffness. That may be all you need to change.

    https://www.daz3d.com/forums/discussion/208346/dforce-exploding-content-possible-work-around

    Aut(h)or:


    mephoria

    Source:


    DAZ Forum


  2. How to Save a Daz Studio dForce Frame as a Morph